The chop saw flip stand is finished. I may add a shelf later. It could have been two or three inches lower. This is a list of the components. Drawings of the keeper latches are attached. I drilled a hole for a 1/4” drop pin in each but didn’t record that in the drawing.
Support frame, Castor legs, 1” 16 gauge square tube, (2), 33”
Support frame, Full length legs, 1” 16 gauge square tube, (2), 38”
Support frame, End rails, 1” 16 gauge square tube, (4), 15”
Support frame, Side rails, 1” 16 gauge square tube, (4), 34”, drill pivot rod holes
Castors (2) 3”
Flipping frame, 1” 16 gauge square tube, ends. 14.75” (2)
Flipping frame, 1” 16 gauge square tube, sides, 29.5” (2), drill pivot rod holes
Hitch pin clip (1 or 2)
Pivot rod, 1/2” round, 18”, drill hole for hitch pin clip
Pivot sleeve, 1/2” schedule 40 pipe, 12.5”, welded to flip frame.
Spacers, 1/2” flat washers, 4
Metal: Hardware: 1/4” x 1.5” bolt
Metal: Hardware: 1/4” washer
Metal: Hardware: 1/4” Nyloc nut
Metal: Hardware: Keeper bar, 1/4” x 1” x 2.5” flat bar with 1/4” hole
No comments:
Post a Comment